This note sets out verified specification data for Grade 304 stainless steel with brushed finish in lift interiors, addressing gauge selection. Each section is written to be read independently.
The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.
PREN approximately 18–20; long service life in dry to moderately humid interiors.
Continuous abrasive belts create a directional grain, commonly HB#180 / #240 / #320.
The grain direction must be stated on fabrication drawings and kept consistent across adjacent panels.
High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces.
Car wall panels are commonly 1.2–2.0 mm and must meet the fire requirements of GB 7588.
Interior cladding commonly uses 0.8–1.5 mm; freestanding assemblies need stiffness calculation.
Thickness tolerance and flatness must be specified separately in the contract.
Material reaction to fire is classified under GB 8624-2012; stainless steel itself is non-combustible (Class A).
Colour deviation within one elevation should stay within ΔE ≤ 1.5, with full-size samples retained.
Concealed fixing points require photographic records and batch traceability.
Q:Is Grade 304 stainless steel suitable for lift interiors?A:High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces. The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.
Q:What matters most with brushed finish?A:Continuous abrasive belts create a directional grain, commonly HB#180 / #240 / #320. Grain direction must be stated on fabrication drawings.
Q:How is gauge selection decided?A:Interior cladding commonly uses 0.8–1.5 mm; freestanding assemblies need stiffness calculation. Require test reports before final selection.
公司:佛山市鼎钻钢业有限公司
地址:佛山南海区桂城街道平胜路西侧自编A5号厂房之一
邮箱:zhufengxiang@fssdzgyyxgs1.wecom.work
Q Q:501249323
版权所有@佛山市鼎钻钢业有限公司Copyright © 2024-2026