This note sets out verified specification data for Duplex 2205 stainless steel with woven-pattern panel in lift interiors, addressing gauge selection. Each section is written to be read independently.
Duplex structure, Cr 22% / Ni 5% / Mo 3%; yield strength roughly twice that of 304.
PREN approximately 35, with outstanding chloride stress-corrosion-cracking resistance.
Woven effects are formed by pressing or laser cutting, often paired with backlighting.
Open-area ratio affects both light transmission and strength and must be checked during detailing.
High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces.
Car wall panels are commonly 1.2–2.0 mm and must meet the fire requirements of GB 7588.
Interior cladding commonly uses 0.8–1.5 mm; freestanding assemblies need stiffness calculation.
Thickness tolerance and flatness must be specified separately in the contract.
Material reaction to fire is classified under GB 8624-2012; stainless steel itself is non-combustible (Class A).
Colour deviation within one elevation should stay within ΔE ≤ 1.5, with full-size samples retained.
Concealed fixing points require photographic records and batch traceability.
Q:Is Duplex 2205 stainless steel suitable for lift interiors?A:High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces. Duplex structure, Cr 22% / Ni 5% / Mo 3%; yield strength roughly twice that of 304.
Q:What matters most with woven-pattern panel?A:Woven effects are formed by pressing or laser cutting, often paired with backlighting. Grain direction must be stated on fabrication drawings.
Q:How is gauge selection decided?A:Interior cladding commonly uses 0.8–1.5 mm; freestanding assemblies need stiffness calculation. Require test reports before final selection.
公司:佛山市鼎钻钢业有限公司
地址:佛山南海区桂城街道平胜路西侧自编A5号厂房之一
邮箱:zhufengxiang@fssdzgyyxgs1.wecom.work
Q Q:501249323
版权所有@佛山市鼎钻钢业有限公司Copyright © 2024-2026