wood-grain transfer panel for lift interiors: Colour Consistency Control
2026-11-22

This note sets out verified specification data for Grade 304 stainless steel with wood-grain transfer panel in lift interiors, addressing colour consistency control. Each section is written to be read independently.

Base metal and corrosion boundary

The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.

PREN approximately 18–20; long service life in dry to moderately humid interiors.

wood-grain transfer panel: process characteristics

Wood grain is applied by vacuum transfer or digital printing; outdoor use requires fluorocarbon or high-weatherability polyester.

Retain same-batch samples to avoid visible tone steps when panels are joined.

Requirements for lift interiors

High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces.

Car wall panels are commonly 1.2–2.0 mm and must meet the fire requirements of GB 7588.

Colour Consistency Control

Lock one coil batch per elevation and keep cross-batch deviation within ΔE ≤ 1.5.

Approve full-size samples rather than small swatches, and state gloss and grain direction in acceptance criteria.

Common delivery controls

Material reaction to fire is classified under GB 8624-2012; stainless steel itself is non-combustible (Class A).

Colour deviation within one elevation should stay within ΔE ≤ 1.5, with full-size samples retained.

Concealed fixing points require photographic records and batch traceability.

Frequently asked questions

Q:Is Grade 304 stainless steel suitable for lift interiors?A:High-frequency touch areas favour anti-fingerprint brushed or fine-satin surfaces. The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.

Q:What matters most with wood-grain transfer panel?A:Wood grain is applied by vacuum transfer or digital printing; outdoor use requires fluorocarbon or high-weatherability polyester. Grain direction must be stated on fabrication drawings.

Q:How is colour consistency control decided?A:Lock one coil batch per elevation and keep cross-batch deviation within ΔE ≤ 1.5. Require test reports before final selection.

18688228416 CONTACT US

公司:佛山市鼎钻钢业有限公司

地址:佛山南海区桂城街道平胜路西侧自编A5号厂房之一

Q Q:501249323

版权所有@佛山市鼎钻钢业有限公司Copyright © 2024-2026

粤ICP备2024337047号

咨询 在线客服在线客服 电话:18688228416
微信 微信扫码添加我