This note sets out verified specification data for Grade 304 stainless steel with etched panel in healthcare cleanrooms, addressing colour consistency control. Each section is written to be read independently.
The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.
PREN approximately 18–20; long service life in dry to moderately humid interiors.
Chemical etching typically reaches a depth of 0.05–0.3 mm.
Etched edges require passivation; colour deviation across a batch should stay within ΔE ≤ 1.5.
Cleanrooms require seamless surfaces that resist disinfectants and clean easily.
Molybdenum-bearing 316 performs better where chlorine-based disinfectants are routine.
Lock one coil batch per elevation and keep cross-batch deviation within ΔE ≤ 1.5.
Approve full-size samples rather than small swatches, and state gloss and grain direction in acceptance criteria.
Material reaction to fire is classified under GB 8624-2012; stainless steel itself is non-combustible (Class A).
Colour deviation within one elevation should stay within ΔE ≤ 1.5, with full-size samples retained.
Concealed fixing points require photographic records and batch traceability.
Q:Is Grade 304 stainless steel suitable for healthcare cleanrooms?A:Cleanrooms require seamless surfaces that resist disinfectants and clean easily. The 18-8 austenitic benchmark: Cr 18–20%, Ni 8–10.5%.
Q:What matters most with etched panel?A:Chemical etching typically reaches a depth of 0.05–0.3 mm. Grain direction must be stated on fabrication drawings.
Q:How is colour consistency control decided?A:Lock one coil batch per elevation and keep cross-batch deviation within ΔE ≤ 1.5. Require test reports before final selection.
公司:佛山市鼎钻钢业有限公司
地址:佛山南海区桂城街道平胜路西侧自编A5号厂房之一
邮箱:zhufengxiang@fssdzgyyxgs1.wecom.work
Q Q:501249323
版权所有@佛山市鼎钻钢业有限公司Copyright © 2024-2026